World
Upholstery & Trim
| Sunvisor Installation W107 |
![]() |
To order by phone, CALL 805-921-0100 or 800-222-9577
Back to How to Install
Home Page
Order Here
The following information is supplied as a customer service
guide. No guarantee or warrantee with regard to results of installations
made by this guide is made or implied.
TOOLS REQUIRED
Phillips Screw Driver
Method:
1. Remove sunvisor from car complete with bracket. Note position of
plastic clip.
2. Remove phillips tension screw.
3. Place the visor on a flat surface, grasp the rod and turn to position
shown in diagram.
4. Holding the plastic clip, wiggle the rod while pulling to remove
it. (If rusty use WD40 or similar)
5. If corroded, use fine sandpaper to achieve a smooth finish on the
removed rod.
6. Lay new visor on a flat surface and push the rod through the vinyl
as far as clip opening.
7. Make sure locator tab on the rod is in position shown.
8. Do not push the rod through the vinyl until you are sure it is in
the metal guides within.
9. Once it is in the guide, push the rod through the vinyl at the non
sealed position.
(You may have to maneuver the rod slightly to align with the non sealed
opening.)
10. Continue to push the rod while sliding on the clip.
11. Gently wiggle the rod further into the vinyl opening on the other
side of the clip opening until the locator tab allows the rod to
rotate freely.
12. Refit the complete visor to the car.
12. Tighten the phillips screw in marked position.

© 3/97 World Upholstery & Trim
05/09/2006
Worlduph.com and XKSS.com are
registered trademarks,
any copying or reproduction
of any kind must be approved by a written contract.
Site maintained by
WorldUpholstery